MAF180C-0150-FQ-S2-HP0-35-V1
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911339769
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
MAF180C-0150-FQ-S2-HP0-35-V1 Induction Motor is manufactured by Bosch Rexroth Indramat. This motor has a Singleturn absolute encoder , EnDat2.1, with 2048 encoder and a Reinforced Bearings bearing. It also has a Balanced with entire key, with Shaft sealing ring shaft and is not equipped with a holding brake.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The Bosch Rexroth MAF180C-0150-FQ-S2-HP0-35-V1 asynchronous housing motor has a squirrel-cage rotor. This motor is associated with compact dimensions. The product can serve as a main drive for any rotary task. The product offers assurance of operational reliability and safety. This device belongs to the MAF series of such offerings. The unit supports different interfaces based on the application. It must not be used without a drive controller. The motor must be grounded properly before it is put into operation.This product has a very hot surface when it is in and soon after use. The device may cause dangerous movements of the drive controller because of its faulty control. This unit is delivered without a holding brake to support its operation. It should be protected against jamming and crushing.
This motor must not be opened in the pressurized state. This product encounters no derating if its key speed equals the rated speed. The device comes with M5 threaded holes along the longitudinal sides of its housing. This unit may have less than the actual protection rating if it is used under unfavorable conditions.The motor comprises an output shaft on its side A. It is cooled by a liquid coolant. This product supports the arbitrary assignment of its inlet and outlet. This device comprises two temperature sensors that are installed in its windings permanently. The unit must neither be stored nor transported along with the coolant. It uses an RGS1003 connector for the encoder connection. This asynchronous housing motor needs two power cables for its connection if a single cable cannot be used due to the large bending radius.
