Product Description:

The MAF180C-0150-FQ-M2-KQ0-35-N1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. Its 180-frame and C-length stator deliver controlled rotary power to conveyors, mixers, and extrusion lines in continuous industrial service. In closed-loop operation, the built-in multi-turn encoder supplies absolute position data, allowing the drive controller to regulate speed and torque with stable response during repeated machine cycles.

The motor has a rated speed of 1500 rpm, enabling continuous duty without excess heating during normal operation. Heat leaves the stator through liquid cooling; coolant flows through a 1/2-inch threaded pair to stabilize temperature under peak demand and during sustained load changes. The housing meets IP65, protecting the windings against dust and washdown spray in enclosed production areas. Position feedback comes from a multi-turn encoder that yields 2048 increments per revolution and transmits them over the EnDat 2.1 digital link for precise synchronization with the inverter. Its electronics accept an encoder supply voltage from 7 to 12 V, matching the power rails delivered by Rexroth drive controllers and helping prevent data errors during long cable runs.

The operating envelope spans 0 to 40 °C, and class F insulation supports internal hot-spot rise before thermal aging accelerates. Installation is flexible because flange and foot mounting are provided, while the drive end is machined with a keyway and dynamically balanced to vibration level A under DIN EN 60034-14. The motor ships without a holding brake and lacks a shaft sealing ring, so external locking or additional sealing must be considered when axial loads or contaminants are present. Because the shaft is supplied without a sealing ring, housing protection does not extend to the coupling area when fluids are sprayed toward the shaft center. The motor also uses standard bearings and winding code 0150.