Product Description:

The MAF180C-0150-FQ-C0-KH0-35-N1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. As a flange- and foot-mounted unit, it supplies constant torque for conveyors, mixers, and other automation loads where heat is removed directly from the stator jacket. This product integrates into systems that follow DIN EN 60034-14 vibration guidelines and provides a standard mechanical interface for industrial installation.

The motor relies on liquid cooling, and coolant is routed through a dedicated connection thread sized at 1/2 inch. This threaded port allows connection to common industrial hoses without adapters. Rotor position feedback is handled by an incremental encoder that delivers 2048 increments per revolution, allowing the controller to issue finely stepped velocity commands. The encoder electronics draw a regulated 5 V supply, which matches the typical logic rail used in drive amplifiers. The motor uses standard bearings to support the plain shaft, and winding code 0150 indicates the electrical design for the rated operating point. The frame designation 180 C refers to the stator diameter and active length for drivetrain matching.

The aluminum housing is sealed to IP65, so airborne dust and low-pressure water jets do not reach the internal windings or the feedback device. Continuous operation is specified at a synchronous speed of 1500 rpm, making the motor suitable for 50 Hz mains or inverter output with minimal slip. Class F insulation tolerates winding temperatures up to 155 °C before aging becomes critical, and vibration level A indicates balanced running in production cells. Because the unit is supplied without a holding brake, any static load retention must be provided by the external drive or by a mechanical locking device. An ambient range of 0 to 40 °C allows full-load performance without derating.