Product Description:

The MAF160C-0200-FQ-M2-FH0-05-N1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. This flange-mounted unit supplies mechanical power to presses, extruders, and test rigs where high continuous torque and compact installation space are important. The motor has a plain shaft, standard bearings, and a frame size of 160 with length code C, making it suitable for IEC-compliant machinery. Its compact housing supports installation where a high power density is needed without adding unnecessary bulk to the machine layout.

Under nominal conditions, the motor produces 59.7 kW of mechanical output at a rated speed of 2000 rpm, with a rated torque of 285 Nm and a rated current of 136 A. The IP65 enclosure helps protect the motor against dust and low-pressure water jets, which supports use in washdown areas. Insulation class F and vibration level A keep the motor within standard operating limits for electrical and mechanical loading. The rotor uses three pole pairs, and continuous duty is supported by liquid cooling through a 1/2-inch connection thread. Power cabling must be at least 2 x 16 mm², the plain shaft is supplied without a shaft seal, and the motor comes without a holding brake.

At standstill, the stator can carry 141.4 A continuously and generate 295 Nm without exceeding allowable thermal limits, while overload torque can rise to 658 Nm before the current is reduced. The torque constant is 2.3 Nm/A, and the continuous rating begins to decrease once the shaft speed exceeds 1500 rpm. Thermal behavior is based on a time constant of 20 min, so coolant flow must remain stable during peak-load cycles. Position feedback is provided by a multiturn absolute encoder with 2048 increments, powered from 7 to 12 V and connected through an EnDat 2.1 interface for digital drive controllers. The motor uses winding code 0200, and ambient operation is limited to 0 to 40 °C with flange mounting.