Product Description:

The MAF160C-0200-FQ-M2-EK0-05-A1 asynchronous motor is produced by Bosch Rexroth Indramat and belongs to the MAF IndraDyn Asynchronous Motors series. As a liquid-cooled motor, it is intended for precise speed control on extrusion lines, presses, and similar equipment where compact torque density is required. In an automation cell, the motor couples to a drive controller and converts three-phase electrical power into continuous rotational motion for demanding industrial processes. Its design also suits applications that need stable output over long duty cycles in limited installation space.

As standard, the unit uses liquid cooling. Heat leaves through a coolant jacket fed by a connection thread measuring 1/2 inch, which supports integration with common coolant plumbing. This arrangement supports high current density without approaching the Class F insulation limit. Rotor position feedback comes from a multi-turn absolute encoder that communicates via EnDat2.1 and provides 2048 increments per revolution. The encoder operates from 7 to 12 V, allowing direct supply from the drive. Flange mounting simplifies installation, and the turnable terminal box on the A-side lets power leads exit in a preferred direction. The motor is supplied without a holding brake, so parked-load retention must be handled elsewhere in the system.

The sealed construction has an IP65 rating, preventing dust ingress and water jets from reaching live components, while the shaft is protected by a shaft sealing ring. At its rated speed of 2000 rpm, the fixed A-side bearing helps keep axial play low, and vibration level A is supported by a rotor that is balanced with a half key. The winding set identified by code 0200 follows DIN EN 60034-14 for vibration limits, and the permitted ambient range of 0 to 40 °C suits typical industrial spaces. A keyed shaft allows direct coupling to standardized hubs, and Class F insulation supports sustained operation under thermal load.