Product Description:

The MAF160C-0200-FQ-M0-FP0-35-V1 is an asynchronous motor from Bosch Rexroth Indramat and belongs to the MAF IndraDyn Asynchronous Motors series. As a liquid-cooled asynchronous housing motor, it is intended for drive systems that must deliver constant torque while keeping stator temperatures under control in confined cabinets or other high-duty applications. The motor connects to hydraulic or chill-water circuits so heat is removed directly from the frame, which helps maintain stable thermal conditions when surrounding airflow is limited. Because the cooling circuit carries heat away at the housing, the unit suits enclosed equipment where fan-based cooling would be less effective. This arrangement is useful in machine layouts that need consistent output without relying on large external ventilation paths.

At its rated operating point, the motor reaches 2000 rpm, a speed matched to common inverter outputs for machine spindles and test stands. Heat is removed by liquid cooling through internal channels, and the coolant ports use a 1/2 inch connection thread for common industrial fittings. The housing is sealed to IP65, which helps keep dust and low-pressure water jets away from internal components during operation. Electrical insulation uses class F materials, allowing the winding system to handle demanding duty cycles with elevated internal temperatures. This combination supports continuous use in areas where both enclosure protection and controlled heat removal are important.

The rotor runs on reinforced bearings, which are intended for belt tension or radial loads above those handled by standard bearing sets. The housing uses flange and foot mounting, allowing either base mounting or direct attachment to a gearbox face. A shaft sealing ring helps prevent coolant or ambient fluid intrusion, and the keyway shaft is balanced with the key to vibration grade A in accordance with DIN EN 60034-14. Operation is approved at ambient temperatures from 0 to 40 °C, so the motor can be used in typical production areas without auxiliary heating. The mounting options also help when aligning the shaft with couplings, pulleys, or other driven components.