Product Description:

The MAF160C-0150-FQ-S2-HG0-35-N3 is an asynchronous housing motor produced by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. As a liquid-cooled unit, it is used in factory automation where stable torque and compact installation are required. Designed for flange and foot mounting, the motor connects to standard inverters and supplies rotational power to conveyor, extruder, or pump modules without an internal brake. It is also suitable for process sections where steady operation is more important than rapid stopping.

Thermal management is handled by liquid cooling. Coolant enters through a connection thread sized at 1/2 inch, allowing direct tie-in to common industrial manifolds. The terminal box can be turned and is positioned on the B-side so power leads can be routed away from heat sources, while the standard bearing arrangement supports general industrial duty. Feedback is delivered by a single-turn absolute encoder over the EnDat2.1 interface; its position granularity is 2048 increments, and the sensing electronics operate on a supply range of 7–12 V. This feedback arrangement allows the connected drive to monitor shaft position and maintain stable speed control during load changes.

The motor is built for harsh shop-floor conditions. The housing carries an IP65 rating, and the plain shaft uses a shaft sealing ring to help block coolant and dust ingress around the bearing area. Nominal operating speed is 1500 rpm, and vibration grade B follows DIN EN 60034-14 for controlled running smoothness. F-class insulation supports elevated winding temperatures, and the motor can operate in ambient temperatures from 0 to 40 °C without derating. The cooling circuit and sealed shaft arrangement help the motor remain suitable for equipment installed on fixed or adjustable bases.