Product Description:

The MAF160C-0100-FQ-S2-KQ0-05-V1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat and assigned to the MAF IndraDyn Asynchronous Motors series. In automated plants, this motor functions as the primary rotary actuator, converting drive current into mechanical torque for conveyor, spindle, or rotary table axes. Its enclosed housing and liquid-cooled design support installations where heat must be removed through the motor body rather than by external airflow.

At a rated speed of 1000 rpm, the unit supplies continuous motion while maintaining an ingress protection rating of IP65, so dust and low-pressure water jets do not reach the internal windings. Its cooling circuit uses liquid cooling, and fluid is routed through a dedicated connection thread for stable thermal management under sustained load. Position feedback comes from a single-turn absolute encoder that communicates via EnDat2.1. The encoder provides 2048 increments, allowing the drive controller to close velocity and position loops without external sensors. The motor has frame size 160 with length code C, and flange mounting simplifies alignment inside compact machinery.

Reinforced bearings support higher belt or gear side loads, and the rotor is balanced with a complete key to reduce dynamic error. The shaft includes a keyway but no shaft sealing ring, so an external seal is required where fluid ingress is possible. This arrangement supports direct coupling where torque transfer is required but sealing is handled at the machine interface. The encoder is powered from 7–12 V, and coolant enters through a 1/2 inch thread that matches common industrial hoses. The motor uses thermal class F insulation and is intended for ambient temperatures from 0 to 40 °C. It complies with vibration severity level A and with DIN EN 60034-14. The motor is supplied without a holding brake and uses winding code 0100.