Product Description:

The MAF160C-0100-FQ-S2-AQ0-35-V1 is built by Bosch Rexroth Indramat as part of the MAF IndraDyn Asynchronous Motors series. This liquid-cooled asynchronous motor is intended for industrial automation zones where continuous torque must be maintained while cabinet heat loads stay low. It is suited for duties such as pump, extruder, and other process-driven axes that run for long periods under steady load. Its cooling layout helps move motor heat away from the enclosure air path. The motor follows DIN EN 60034-14 for mechanical balance, and because it is supplied without a holding brake, external braking or drive torque must hold the axis when it is idle.

The motor uses liquid cooling through a threaded connection, and the port is tapped to 1/2 inch so standard plumbing can connect directly to the stator jacket. Feedback comes from a single-turn absolute encoder over EnDat2.1, with a resolution of 2048 increments and a supply requirement of 7–12 V. The encoder also provides diagnostic data to the drive. The windings use code 0100 in a C-length frame, which matches the motor’s intended torque range and installation size. The permissible ambient temperature range is 0 to 40 °C. Power enters on the A-side through a sealed connector, which helps keep cable routing clear of nearby cabinet devices.

Reinforced bearings, flange and foot mounting points, and a shaft balanced with a complete key help keep vibration within level A, even though the keyed output has no shaft sealing ring. The housing carries an IP65 protection rating to resist dust and water jets during operation. The motor uses a 160 frame, matching the external dimensions required by larger pump and extruder applications. At a rated speed of 1000 rpm, class F insulation supports cyclic overloads without exceeding winding temperature limits.