Product Description:

The MAF130D-0250-FQ-S6-HG0-35-A1 is a liquid-cooled asynchronous housing motor manufactured by Bosch Rexroth Indramat and assigned to the MAF IndraDyn Asynchronous Motors series. It is intended for flange- or foot-mounted drive stations that must remove heat without external airflow, allowing sealed enclosures to power conveyors, mixers, or pump lines inside automated cells where cleanliness and continuous duty are required. With frame size 130 and frame length code D, the motor uses a large stator stack that supports high power density in demanding industrial installations.

The motor relies on liquid cooling that circulates through a connection thread sized 1/4 inch, and this arrangement carries heat away from the stator so full torque is available at the rated speed of 2500 rpm. A protection rating of IP65 blocks dust and low-pressure water jets, while a shaft sealing ring protects the plain shaft opening. Position data come from a single-turn absolute encoder for Ex-type motors that delivers 2048 increments to the drive through the EnDat 2.1 interface, supporting closed-loop speed regulation. Mechanical stability is supported by an A-side fixed bearing, and vibration level A under DIN EN 60034-14 keeps dynamic loads within limits. The winding code 0250 and insulation class F indicate the motor’s thermal class, and the unit comes without a holding brake, so an external locking device is required when power is removed.

An encoder lead of 15 m allows remote mounting of the controller, and the sensor electronics operate from 7 to 12 V supplied by the feedback card. Operation is permitted from 0 to 40 °C, which matches typical machine-room conditions for industrial equipment. The turnable terminal box on the B-side simplifies cable entry in tight panels and helps route power and feedback connections more cleanly.