Product Description:

The MAF130D-0250-FQ-C0-DH0-05-H1 belongs to the MAF IndraDyn Asynchronous Motors series manufactured by Bosch Rexroth Indramat. It is a liquid-cooled asynchronous housing motor for automated machinery that requires dependable rotational power. Heat is removed directly from the stator instead of relying on external airflow, which helps maintain stable operating temperatures during sustained operation. This arrangement is useful in machine layouts where thermal control must remain consistent without adding separate air-cooling hardware around the motor body.

The motor reaches a rated speed of 2500 rpm, which is its rated operating speed at the nameplate voltage and frequency. Its bearings are intended for high-speed service so radial loads remain within permissible limits at that velocity. Cooling is provided by liquid cooling through a 1/4-inch connection thread, allowing coolant to circulate and keep winding temperature below the Class F limit. Rotor position is reported by an incremental encoder that generates 2048 increments per revolution and requires a 5 V supply, allowing the drive to maintain precise speed control and monitor shaft movement during load changes. The housing is sealed to IP65, which keeps out dust and protects against low-pressure water jets so the motor can be installed outside a sealed cabinet. Frame size 130, frame length code D, and winding code 0250 match the motor to compatible converters, while vibration level Class A, the lack of a holding brake, the absence of a shaft sealing ring, and a turnable terminal box on the right side support straightforward installation and cable routing.

Mechanical integration is through flange mounting, and torque is transferred by a plain shaft that mates with clamped couplings. This shaft style leaves the output end smooth rather than keyed, so the coupling must grip the shaft directly. Compliance with DIN EN 60034-14 confirms measured vibration limits and balance quality for rotating electrical machines. The permissible ambient range of 0 – 40 °C allows operation in standard production halls without extra enclosure cooling. Insulation class F provides thermal headroom for intermittent overloads.