Product Description:

The MAF130D-0200-FQ-S2-AH0-35-N1 is an asynchronous housing motor produced by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. It delivers rotational power to automated presses, extruders, and transfer stations where precise speed regulation and high thermal loading are common. The product’s liquid circuit is routed through an internal jacket so the motor can be mounted on either a flange or a foot plate without adding external coolers, allowing compact installation inside electrical or mechanical drive modules.

Process heat is extracted by liquid cooling, with coolant entering and exiting through a connection thread sized at 1/4 inch; this threaded port mates directly with common hydraulic fittings and helps keep stator temperature stable under heavy duty. A single-turn absolute encoder using the EnDat2.1 interface provides closed-loop feedback, and its resolution of 2048 increments lets the drive controller resolve fine position changes at low speed. The encoder electronics operate from a 7–12 V supply, reducing signal noise on long feedback cables. Nominal output speed reaches 2000 rpm, matching the 0200 winding code and providing a predictable speed-torque curve. Power is delivered through a right-angle connector on the A-side of the housing, and standard bearings minimize shaft vibration while supporting continuous radial loads.

The aluminum frame is sealed to IP65, blocking dust and water jets so the motor can be washed down in food or chemical areas within the permissible ambient range of 0 – 40 °C. Windings use an F insulation system that tolerates 155 °C hot-spot temperatures, while overall balance stays within vibration level A per DIN EN 60034-14. The plain shaft is supplied without a shaft sealing ring, and the unit is delivered without a holding brake, so external mechanical locks must secure vertical axes.