Product Description:

The MAF130D-0200-FQ-M2-DH1-05-N1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. Intended for automated duty cycles that run continuously, the unit uses flange mounting to integrate directly onto machine frames. By circulating coolant through an internal jacket, the motor provides stable torque output in compact installations where airflow is limited. This layout is well suited to enclosed equipment where heat must be carried away through a coolant circuit rather than dissipated by surrounding air. The motor can support steady production operation in machinery that runs for long shifts.

At a nominal running point of 2000 rpm, the rotor speed aligns with typical inverter drive ranges used on production conveyors or test benches. An electrically released brake delivers 80 Nm of static holding capacity, preventing back-driving when control power is disengaged. Coolant is fed through a 1/4 inch connection thread, so thermal loads are removed with minimal external plumbing. The cast housing carries a protection rating of IP65, enabling installation in wash-down zones. Position feedback arrives via a multi-turn absolute encoder that generates 2048 increments per revolution and transmits them over EnDat 2.1 for drive alignment. Power conductors enter from the right through a rotatable terminal box, giving flexibility in cabinet layout while helping maintain orderly cable routing. The multi-turn feedback arrangement also helps the connected drive maintain position reference during repeated stops and restarts.

The encoder electronics are powered by an input window of 7–12 V, allowing interface boards to share low-voltage rails with other sensors. The windings use insulation class F, and vibration level A supports smooth mechanical operation in accordance with DIN EN 60034-14. The frame uses size code 130 with length code D, so the stator stack provides the required torque capacity without increasing motor diameter. Winding code 0200 matches the electrical characteristics to the liquid-cooling arrangement, and the permissible ambient range of 0 to 40 °C suits cabinets with conditioned air. Low-voltage feedback supply and insulated windings support stable interaction between the motor, the encoder system, and the connected drive electronics.