Product Description:

The MAF130D-0100-FQ-S2-AQ0-05-N1 is an asynchronous housing motor from the MAF IndraDyn Asynchronous Motors series manufactured by Bosch Rexroth Indramat. As a liquid-cooled asynchronous housing motor, it is intended for tightly packed automation cells where forced ventilation is impractical and steady torque is required. The unit integrates directly with drive packages in material-handling, test-stand, and forming equipment, providing a sealed torque source that transfers thermal energy to an external coolant circuit instead of the surrounding air.

Rated operation is reached at 1000 rpm, a speed that pairs the 130-frame stator with high-pole-count windings to produce strong low-speed torque. Coolant enters through a 1/4-inch connection thread beside the power connector, which supports secure liquid circulation. The enclosure meets IP65, so dust and water jets do not affect the winding insulation. Rotor position is delivered through the EnDat2.1 serial interface, and the single-turn absolute encoder resolves motion into 2048 increments. Power reaches the stator through a connector on the A-side, and the motor uses standard bearings, vibration class A, and winding code 0100 for its mechanical balance and electrical setup.

The motor uses flange mounting, allowing direct attachment to gearboxes or machine frames without alignment sleeves. The shaft has a keyway and is balanced with a complete key, while the front end is supplied without a shaft sealing ring to simplify service in clean coolant environments. The unit is supplied without a holding brake, so static loads must be secured by the drive or by external locking hardware. Thermal integrity relies on class F insulation, and safe operation is permitted only between 0 °C and 40 °C ambient. The motor has frame length code D and complies with DIN EN 60034-14.