Product Description:

The MAF130D-0100-FQ-S0-BH0-05-N1 is an asynchronous motor built by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. It is a liquid-cooled housing motor intended for industrial automation tasks that call for steady torque and accurate speed control within compact machine frames. By pairing with an inverter, the unit supplies regulated rotary motion to material-handling lines, process drives, and similar equipment where continuous duty and thermal stability are priorities. This operating concept suits applications that need stable output over long production cycles without relying on external ventilation around the motor body.

The mechanical layout uses flange mounting, so the housing bolts directly to the driven machine and keeps alignment consistent. A frame size of 130 mm and frame-length code D provide a moderate axial length while preserving stator volume for continuous industrial duty. The rotor turns on standard bearings, and a plain shaft is provided for couplings that do not require keys. No shaft sealing ring is fitted, which is suitable where outside contamination is limited and a sealed shaft interface is not required. Nominal operation is set at 1000 rpm, a speed that suits slow-running mixers, extruders, or geared drive stages. Dynamic balance meets vibration level A, helping the motor run smoothly in equipment that depends on stable rotation. Dimensional and vibration requirements follow DIN EN 60034-14, so the motor matches common industrial expectations for mounting accuracy and running behavior.

Thermal energy is removed through liquid cooling, and coolant enters and leaves through a connection thread sized 1/4 inch for connection to common hose fittings. The cooling ports are located on the B-side together with the power connector, which keeps the main service connections on one face of the motor. Protection class IP65 helps keep dust and low-pressure water jets away from internal components during operation. The motor can run in ambient air from 0 to 40 °C without derating, and class F insulation allows winding temperatures up to 155 °C. It is supplied without a holding brake, so any load that must remain fixed at standstill needs external holding force or drive-produced torque. Winding code 0100 identifies the electrical configuration used with compatible drive controllers.