Product Description:

The MAF130C-0250-FQ-S2-AP0-35-N1 is a liquid-cooled asynchronous housing motor supplied by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. It is used as a prime mover in packaging lines, presses, and test rigs where compact installation space and stable thermal behavior are important. The motor converts three-phase electrical power into rotary motion while coolant flows through internal channels to carry heat away from the stator. This arrangement supports steady operation in applications that run for long periods under changing mechanical load.

The motor has a rated speed of 2500 rpm, and winding code 0250 is matched to that operating point. Heat is removed by liquid cooling, and the housing has an IP65 protection rating to resist dust and low-pressure water jets. A single-turn absolute encoder with 2048 increments supplies position data to the drive, and the encoder housing connects through a power connector instead of a terminal box. The shaft uses a keyed output with a shaft sealing ring, while flange and foot mounting allow the motor to fit different machine layouts. The motor can operate in ambient temperatures from 0 to 40 °C, and it uses standard-fit bearings with vibration level A.

The cooling circuit uses a 1/4 inch connection thread, which helps match common hose fittings used on industrial equipment. Motion feedback is transmitted through EnDat2.1, and the encoder electronics operate from 7–12 V supplied by the drive controller. Power is routed on the A-side of the stator, leaving the opposite face open for related machine hardware. The motor is supplied without a holding brake, so any load that must remain fixed at standstill requires external holding force. Dynamic balance conforms to DIN EN 60034-14, and the complete key balance suits keyed couplings used on general machine drives.