Product Description:

The MAF130C-0200-FQ-M2-AG0-05-N1 is an asynchronous housing motor produced by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. An internal liquid circuit removes heat so rated torque can be delivered continuously during automated material-handling or machining routines. Frame size 130 and length code C set the mechanical envelope, while a plain shaft simplifies coupling to gear reducers or belts. Delivered without a holding brake, the motor is intended for systems that rely on drive torque or external clamps for position retention.

Thermal energy leaves the stator through a cooling jacket that terminates in a threaded port. The port accepts fittings with a 1/4 inch thread size, making hose integration straightforward. Mechanical attachment uses flange mounting, and a standard bearing set supports radial and axial loads generated at the rated speed of 2000 rpm. The housing carries an IP65 protection rating, so the interior remains sealed against dust and water jets within the permissible ambient temperature range of 0 to 40 °C. Power enters on the A-side of the stator through a locking connector, and a shaft sealing ring helps prevent coolant or lubricant from migrating along the plain shaft. Vibration level A is maintained, and winding code 0200 identifies the electrical arrangement of the stator coils.

Position feedback is delivered by a multi-turn absolute encoder that communicates via EnDat2.1 and resolves rotor angle to 2048 increments per revolution. The encoder electronics accept 7–12 V from the drive, allowing low-voltage cable routing inside the control cabinet. Class F insulation permits winding temperatures up to 155 °C, supporting continuous operation under liquid cooling. Dynamic balancing follows DIN EN 60034-14, supporting stable mechanical operation during precise speed regulation.