Product Description:

The MAF130C-0150-FQ-S2-AH1-35-N1 is a liquid-cooled asynchronous housing motor manufactured by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. Designed for flange or foot installation, it serves as the primary drive motor in automated lines that require stable rotational output and efficient heat removal during continuous duty. Its asynchronous design suits industrial equipment that must run for long periods with dependable torque delivery. The motor is also well suited to machine layouts where a compact, enclosed drive package is preferred over separate external cooling hardware.

The motor uses a standard rolling bearing set that supports the 130 mm frame while keeping vibration within level A. Its nominal speed is 1500 rpm, which matches the 0150 winding so the drive inverter can deliver rated torque without excessive magnetic loading. Heat is removed by liquid cooling routed through a 1/4-inch connection thread, and the A-side power connector stays clear of coolant fittings for easier access. The housing is sealed to IP65, preventing dust and low-pressure water jets from reaching the stator. Position feedback comes from a single-turn absolute encoder with 2048 increments through the EnDat2.1 interface, allowing precise speed regulation from a sensor supply of 7 to 12 V.

An electrically released holding brake delivers 80 Nm of static torque so vertical loads remain secured when the inverter is de-energized. The plain output shaft is supplied without a shaft sealing ring, which reduces friction in applications where external fluid ingress is already controlled by the machine frame. Electrical power is routed through a keyed connector on the A-side, and the C-length frame follows the dimensional tolerances of DIN EN 60034-14. The motor uses an F insulation system and is intended for surrounding air temperatures from 0 to 40 °C. This arrangement fits installations that already use a coolant circuit and need consistent operation under steady load.