Product Description:

The MAF130C-0150-FQ-N0-KL0-05-N3 belongs to the MAF IndraDyn Asynchronous Motors series from Bosch Rexroth Indramat. As a liquid-cooled asynchronous housing motor, it supplies constant torque for conveyors, extruders, and other continuous-duty axes in automated lines. The frame integrates directly with Rexroth drive electronics, allowing a compact drive source to be placed close to the load while diverting most heat into a coolant circuit instead of the surrounding air. This layout supports tightly packed cabinets and sealed production spaces where low ambient heat buildup is important.

At the mechanical interface, the unit uses a flange mounting pattern compatible with IEC B-face machinery, and its housing diameter corresponds to a 130 frame size for predictable coupling selection. This arrangement supports direct face mounting on common machine structures. Nominal speed is 1500 rpm, letting the connected inverter derive synchronous motion from 50 Hz mains. Heat leaves the stator through liquid cooling channels accessed by a 1/4-inch connection thread, so cabinet airflow is unnecessary. A sealed enclosure rated IP65 resists dust and water jets. Standard rolling bearings support the rotor, the motor is supplied without a holding brake, and no encoder is installed. The motor has a keyed output shaft without a sealing ring.

The rotor is balanced with a half-key and uses vibration grade B. The motor uses F class insulation, and winding code 0150 identifies the stator winding used with matching drive currents. It follows DIN EN 60034-14 for vibration limits, and the C frame length indicates the active stack height in this motor size. Permissible ambient operation spans 0 °C to 40 °C. Because the shaft has no sealing ring, the mounting area should remain protected from process fluids.