Product Description:

The MAF130C-0150-FQ-M2-AP0-05-N1 is a liquid-cooled asynchronous housing motor built by Bosch Rexroth Indramat and assigned to the MAF IndraDyn Asynchronous Motors series. Designed for flange installation on machine frames, the unit converts inverter output into rotational motion for pumps, extruders, and material-handling axes where continuous torque is required under tight thermal limits. Its 130 mm frame size and C length code place it in the mid-range of the series, while the A-side power connector simplifies routing inside compact cabinets.

The housing carries a protection rating of IP65, so internal windings and bearings are isolated from airborne dust and low-pressure water jets on the production floor. Process heat is removed by liquid cooling; this method stabilizes the stator temperature without external airflow, enabling full power in sealed enclosures. Coolant enters and leaves through a connection thread sized to 1/4 inch, allowing standardized pipe fittings in manifold designs. Under rated conditions, the rotor turns at 1500 rpm, matching common 50 Hz line frequencies when driven by a vector inverter. Position feedback travels over an EnDat 2.1 interface, giving the controller bidirectional digital communication for position monitoring and error detection.

The multi-turn encoder resolves shaft position to 2048 increments, so indexing tables and feed drives can repeat moves without manual recalibration. Operation is specified within an ambient range of 0 to 40 °C, and staying inside this range helps prevent condensation while keeping lubricant viscosity stable. Class F insulation tolerates winding temperatures up to 155 °C, adding thermal headroom during brief overloads imposed by acceleration profiles. The motor-end face is equipped with a shaft sealing ring, which helps block coolant splash and grease egress while maintaining vibration level A in continuous service.