Product Description:

The MAF130C-0100-FQ-S0-BH0-05-R1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. It is intended to drive machine axes and spindles where high continuous torque density is needed while maintaining a stable thermal profile. In an automation cell, the unit converts electrical power from an inverter into controlled mechanical rotation, allowing precise speed regulation for conveyors, tooling stations, or ancillary equipment.

It employs liquid cooling circulated through an internal jacket to remove heat directly from the stator laminations, increasing continuous power capability compared with air-cooled designs. The coolant ports are machined with a 1/4 inch connection thread, allowing standard hydraulic fittings to be attached without adapters. In operation, the motor sustains a rated speed of 1000 rpm, so the drive controller can hold constant torque at relatively low shaft speed, which is useful for mixers or indexing tables. Its housing meets the IP65 protection class, preventing dust ingress and withstanding low-pressure water jets. Continuous service is specified for ambient temperatures from 0 to 40 °C, ensuring thermal calculations remain accurate inside typical factory enclosures.

Power is supplied through a connector positioned on the B-side of the frame, simplifying cable routing when the motor flange faces the workstation. The motor uses flange mounting, and the plain centering diameter follows DIN tolerances for quick alignment. Class F insulation permits winding temperatures up to 155 °C before degradation, while the rotor is machined with a plain shaft that can be coupled by shrink disk or keyed hub as required. The design omits a holding brake and a shaft sealing ring, so external locking or an additional seal must be provided if axial fluids are present. Frame size 130 with length code C sets the magnetic core volume, winding code 0100 indicates resistance and inductance for drive matching, vibration level A limits displacement during precision tasks, and the construction conforms to DIN EN 60034-14 balance requirements.