Product Description:

The MAF130C-0100-FQ-S0-AQ0-05-N1 is an asynchronous housing motor produced by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. Classified as a liquid-cooled unit, it fits tightly packed automation cells where heat must be removed through the housing instead of relying on surrounding air. In integrated drive systems, it provides steady torque for conveyors, extruders, and forming equipment. Its housing layout also supports direct installation on machine frames or gear units where compact placement matters, and the asynchronous motor design is well suited to continuous industrial operation.

This model uses liquid cooling circulated through a jacket fed by a 1/4 inch connection thread, allowing the motor to connect to a closed-loop chiller circuit. The enclosure carries an IP65 rating to resist dust and low-pressure water jets, and the insulation system uses class F windings for continuous industrial duty. The rotor has a rated speed of 1000 rpm, which supports torque-focused operation with low mechanical vibration, and power enters through a sealed connector on the A-side for orderly cable routing. Continuous operation is permitted in ambient air from 0 to 40 °C, while the coolant path helps stabilize stator temperature during demanding load cycles. The sealed electrical interface also helps protect the connection point in areas where moisture or airborne debris may be present.

The motor is supplied without a holding brake, so any static load must be retained by the drive or by external clamping hardware. Shaft balancing is specified as balanced with a complete key, which matches the keyed shaft arrangement and helps reduce imbalance after couplings are installed. The motor uses flange mounting and standard rolling bearings, and the housing omits a shaft sealing ring to reduce friction while the sealed enclosure protects internal components. Frame designation 130 mm, length code C, and winding code 0100 establish the motor’s dimensional and electromagnetic layout, and vibration behavior is aligned with DIN EN 60034-14. This arrangement suits equipment that needs stable rotation and direct mechanical integration without added brake hardware.