Product Description:

The MAF130B-0150-FQ-S2-AQ0-05-N1 is an asynchronous housing motor produced by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. It serves as the prime mover in automated lines by converting three-phase electrical input into controlled shaft rotation for pumps, material-handling rollers, and similar plant equipment. Its sealed housing allows installation directly on machine frames or inside enclosures, which helps shorten cable runs and keeps the drive close to the driven load. This layout is suited to applications that need steady torque delivery without placing a separate motor outside the guarded machine area. An internal thermal path supports stable winding temperature during long operating periods.

Mechanical integration uses flange mounting sized for frame 130 with the B-length stator package. The rotor is balanced with a complete key and runs on standard bearings, which keeps vibration within Level A during normal operation. Continuous duty is supported at a rated speed of 1500 rpm, and winding code 0150 identifies the electrical design used in this motor. Heat is removed by liquid cooling through a threaded service connection, and the cooling port uses a 1/4 inch thread for direct hose attachment. The liquid circuit transfers thermal energy away from the stator jacket, which helps the motor remain compact while supporting sustained load. The housing has an IP65 rating, which helps keep out dust and low-pressure water jets. Power connects on the A-side through a pluggable connector, so the mounting interface can remain undisturbed during cable service.

Closed-loop positioning uses the EnDat2.1 serial interface with a single-turn absolute encoder that provides 2048 increments and operates from a regulated 7–12 V supply. That feedback arrangement allows the control system to track rotor position immediately after startup without relying on a coarse speed signal. The motor is supplied without a holding brake, so static loads must be held by the drive controller or by external locking hardware when the axis is stopped. Class F insulation supports continuous thermal duty, and operation is permitted in ambient temperatures from 0 to 40 °C. Residual vibration follows DIN EN 60034-14, and the output shaft has a machined keyway without a shaft sealing ring to reduce friction.