Product Description:

The MAF100D-0200-FQ-C0-AG0-05-N1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat and supplied within the MAF IndraDyn Asynchronous Motors series. Intended for tightly controlled industrial automation axes, the unit combines an induction rotor with an integrated liquid jacket to remove heat at the source. Its construction allows flange mounting directly into machinery frames, and the motor serves as a high-torque drive element that maintains stable performance in compact installations where airflow around the housing may be limited.

At its rated operating point, the rotor reaches 2000 rpm, giving drive controllers a predictable speed reference for vector control loops. Thermal management is handled by liquid cooling, routed through a rear manifold that terminates in a 1/4 inch connection thread, so standard plant coolant circuits can be attached without adapters. Position feedback comes from an incremental encoder that resolves 2048 increments per revolution and is energized from a 5 V supply. The enclosure is sealed to IP65, preventing dust ingress and resisting low-pressure water jets during washdown routines. The power connector is positioned on the A-side, and the motor uses frame size 100 with length code D. Winding code 0200 is intended for converters that provide the required current density, and standard bearings support typical radial and axial loads while vibration level A helps limit transmitted motion.

Operation is permitted between 0 - 40 °C, allowing installation in controlled industrial environments without special ambient conditioning. Compliance with DIN EN 60034-14 indicates the applicable balancing quality and vibration limits for the motor. Because the motor is supplied without a holding brake, vertical axes require external holding force when power is removed. The motor has a plain shaft with a sealing ring that helps protect internal lubricants, and insulation class F supports winding temperatures up to 155 °C. Its flange interface also aligns with the mounting pilot dimensions used on size-100 machines.