Product Description:

The MAF100C-0200-FQ-S2-AQ0-05-N1 is supplied by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. It is a liquid-cooled asynchronous housing motor intended to drive production axes that run continuously and must reject heat through the machine’s coolant circuit. In automated lines, the design supports high cycle-rate material handling, packaging, or forming stations that need stable torque while remaining sealed against shop contaminants.

The motor relies on liquid cooling routed through a connection thread sized at 1/4 inch, allowing rigid piping to remove winding and bearing heat. Its enclosure carries an IP65 rating, so airborne dust and directed water jets cannot reach internal parts. A rated speed of 2000 rpm suits conveyor or spindle drives that couple directly through a keyed shaft; the shaft is balanced with a complete key, machined with a keyway, and supplied without a shaft sealing ring. The motor mounts on a flange, uses a connector on the A-side for the power leads, and follows vibration level A guidelines. Standard bearings, F-class insulation, and the DIN EN 60034-14 mechanical standard allow operation in ambient air from 0 to 40 °C without derating. Frame size 100 with length code C and winding code 0200 set the stator geometry and electrical values used by the matched inverter.

An EnDat2.1 interface links the control loop to the integrated feedback device, whose resolution is 2048 increments and whose supply range is 7 to 12 V. The encoder is a single-turn absolute encoder, so position data is available when power is applied and homing is not required. The motor is supplied without a holding brake, so vertical loads must be restrained by external clamping or drive torque. The threaded coolant connection helps maintain stable thermal conditions during rapid duty changes.