Product Description:

The MAF100C-0200-FQ-S2-AH0-35-N4 from Bosch Rexroth Indramat is a member of the MAF IndraDyn Asynchronous Motors series. This liquid-cooled asynchronous housing motor is built for drive axes that need steady torque under high thermal loads. It uses a 100 frame with length code C, offers a plain shaft for direct coupling, and installs through flange and foot mounting. In automated machining centers, it converts electrical energy into rotational motion for pumps, spindles, or transport modules.

Its thermal management relies on liquid cooling, and the coolant enters through a connection thread sized at 1/4 inch, simplifying hose coupler selection. The power conductors reach the stator from the A-side through a sealed connector, while a standard bearing set supports the rotor and keeps vibration within level C. Position feedback comes from a single-turn absolute encoder that transmits data over the EnDat2.1 interface, and the code disc delivers 2048 increments per revolution so the drive controller can track angular position in fine steps. The sensor electronics accept a supply of 7-12 V, which matches common controller output rails and avoids separate conditioning hardware.

At a rated speed of 2000 rpm, the motor delivers constant torque and uses winding code 0200 for its electrical configuration. It does not include an integrated holding brake, so any static load must be held by the driven mechanism or the control system. Protection category IP65 blocks dust ingress and low-pressure water jets; however, there is no shaft sealing ring, so external sealing must be arranged if direct washdown contact is expected. Class F insulation lets the winding endure higher temperatures during continuous operation with active coolant flow. The stator frame can operate in ambient conditions from 0 to 40 °C without derating, provided the coolant circuit is active.