Product Description:

The MAF100C-0150-FQ-S2-LK0-05-A1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. Designed for flange installation inside machine frames, the unit delivers controlled shaft rotation to mixers, presses, and material-handling axes that operate under continuous load. By pairing the rotor with an absolute feedback device, the motor allows the connected drive controller to monitor position and slip so it can maintain commanded speed and torque in real time.

At its rated operating point, the shaft turns at 1500 rpm, a speed that aligns with 50 Hz inverter output and supports gear-free coupling to standard process equipment. Heat generated by the stator is removed through liquid cooling. Coolant circulates in a jacket fed by a 1/4 inch connection thread, helping keep winding temperature within the class F limit. Feedback is delivered by a single-turn absolute encoder that communicates through the EnDat2.1 interface, provides 2048 increments per revolution, and draws a regulated 7–12 V supply. An A-side fixed bearing absorbs axial forces, while shaft balancing with a half key and a machined keyway helps reduce radial runout. The motor uses frame size 100 with length code C, which provides the required electromagnetic cross-section without increasing overall width, and flange mounting mates directly with ISO motor adapters.

The motor housing has an IP65 protection rating and a shaft sealing ring, which helps prevent dust and low-pressure water jets from entering during washdown cleaning. Compliance with DIN EN 60034-14 means the vibration level is graded as class A, so dynamic forces transmitted to the machine base remain within accepted limits. Operation is specified in ambient temperatures from 0 to 40 °C. A left-side power connector simplifies wiring in tight panels, and the lack of a holding brake shortens the assembly for drives that rely on external clamping.