Product Description:

The MAF100C-0100-FQ-S2-BG1-05-N1 is an asynchronous housing motor produced by Bosch Rexroth Indramat within the MAF IndraDyn Asynchronous Motors series. It combines a compact frame with a plain shaft and standard bearings, allowing direct coupling to pumps, extruders, or test stands. This unit supplies continuous mechanical power for automated lines, and its single-turn absolute encoder provides position data so that controllers can maintain commanded speed and torque with minimal vibration. Its power connector is oriented on the B-side, which helps simplify cable routing inside compact cabinets.

This motor relies on liquid cooling through a 1/4-inch connection thread, allowing heat to be removed directly from the stator. Its cast housing is rated IP65, so dust ingress and water jets do not reach the internal windings. Under nominal conditions, the rotor turns at 1000 rpm, and an electrically released brake supplies 24 Nm of static holding torque for secure positioning during downtime. Rotor position is delivered to the drive through the EnDat 2.1 serial encoder interface. A shaft sealing ring guards the front bearing against lubricant spray, and the permissible ambient temperature ranges from 0 °C to 40 °C when coolant flow is present.

The feedback device is a single-turn absolute encoder that resolves rotation into 2048 increments and draws power from a 7–12 V supply provided by the drive controller. Electrical safety margins are supported by insulation class F, while mechanical stability follows vibration grade A in DIN EN 60034-14. The motor attaches through a flange interface that matches common IEC layouts, and winding code 0100 indicates an electromagnetic design optimized for low-speed, high-torque service. A liquid-tight housing preserves internal clearances when coolant circulates.