Product Description:

The MAD160C-0150-SA-S2-BQ0-35-V1 is manufactured by Bosch Rexroth Indramat as part of the MAD IndraDyn A Motors series. Classified as a servo motor, it drives precision axes in presses, gantry stages, and material-handling cells. Its frame size 160 and frame length C give the motor a compact housing for its torque class. All power and signal conductors exit on the B-side through a multi-pin connector, which keeps cable routing at one end of the housing, and winding code 0150 identifies the electrical layout of the stator.

Its rated speed of 1500 rpm provides a stable operating point for synchronous motion tasks. The rotor turns on reinforced bearings, allowing the motor to handle higher radial or axial loads from coupled machine elements. With an enclosure protection class of IP65, internal assemblies are sealed against dust and low-pressure water, which supports use outside a control cabinet when the surrounding installation is suitable. Heat is removed by an integral axial fan, and this forced airflow keeps winding temperature within insulation class F during continuous duty. Vibration grade R controls running balance, a whole-key balanced shaft without a shaft seal reduces friction, and the stator completes 2048 electrical periods per mechanical revolution to support precise vector control.

Position data are provided by a single-turn absolute encoder EnDat 2.1, which reports rotor angle at power-up and removes the need for a homing cycle in many applications. Emergency load retention must be handled externally because the unit is supplied without a holding brake. Installation flexibility comes from flange and foot mounting, allowing either baseplate or faceplate attachment according to the machine layout. Continuous service is permitted between 0–40 °C, which fits normal factory conditions. When the axis must remain fixed after power is removed, holding force has to come from the drive or from the machine mechanism.