MAD160C-0150-SA-S2-BH0-35-H3
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911324172
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
MAD160C-0150-SA-S2-BH0-35-H3 Spindle Motor manufactured by Bosch Rexroth Indramat. This motor has a cooling mode with an Axail Fan, Blowing and a Singleturn Absolute, 2048 increments encoder. It also has a mounting style of Flange and a Standard bearing.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MAD160C-0150-SA-S2-BH0-35-H3 asynchronous housing motor offered by Bosch Rexroth always works in conjunction with a drive controller from the same manufacturer. This motor encounters a temperature change rate of 0.5 degrees C/min during its operation. The product relies on a fan for its cooling action. This device depends on a motor protective switch and a cable to connect its fan to the supply network. The unit has two KTY84-type PTC temperature sensors permanently installed in its windings. Its connection torques must never be exceeded.
This motor is intended to be operated within the specified ambient operating conditions. The product uses a RGS1004 connector for its encoder connection. This device needs two cables for its power connection if a single cable cannot be used because of the large bending radius. The unit must not be directly connected to a 50/60 Hz mains power supply. Its temperature sensor must be connected with proper polarity if it is used externally to measure the temperature. This motor can be fitted only with gearboxes of the GTM series. The product cannot be operated with a sealing air connection. This device depicts a surface temperature of over 60 degrees C during and immediately after operation. The unit may cause property damage if it is not used as intended. It may be needed to connect additional sensors and actuators to control and monitor it.
This motor should be retained in its original state without any structural changes. The product must not be exposed to environmental conditions that do not meet the ambient conditions. This device should be operated only by qualified personnel. The unit takes up to 140 minutes after it has been disconnected from the power supply. Its drive controller depicts dangerous movements if the motor has defective components. This asynchronous housing motor encompasses permanent magnets in its rotor.
