MAD160B-0100-SA-S2-AK0-05-N1
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911328069
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
MAD160B-0100-SA-S2-AK0-05-N1 Spindle Motor manufactured by Bosch Rexroth Indramat. This motor has a cooling mode with an Axail Fan, Blowing and a Singleturn Absolute, 2048 increments encoder. It also has a mounting style of Flange and a Standard bearing.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MAD160B-0100-SA-S2-AK0-05-N1 asynchronous housing motor delivered by Bosch Rexroth encompasses an output shaft with a keyway. This motor is balanced with a half key. The product has an optimized construction. This device can be used under unfavorable conditions. The unit along with the drive controller offers a drive solution with open functionality. It must be used after reading and understanding the associated safety instructions. The motor connection must be done with cables from the same manufacturer.This product should not be used if the operating conditions fail to comply with the specified ambient conditions. The device assembly, mounting, and installation must be done as per the instructions given in its documentation. This unit is not meant to be operated in areas where there is a possibility of an explosion hazard.
Its housing surface can cause burns when it is hot if it is handled without protective gloves. This motor can take up to 140 minutes to cool down after it has been switched off.The product portrays a cylindrical shaft end. This device should not be installed or operated if it is found to be damaged or defective. This unit is majorly installed and operated in forming machines. It should not be connected with components that are not mentioned in its documentation. This asynchronous housing motor can be installed vertically with the output shaft facing upward or downward. The product handling must be undertaken only by qualified personnel or people with the expertise to do so. This device should be disconnected from the power supply before any work is done on it.
