MAD160B-0050-SA-S2-AH0-05-N1
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911323877
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
MAD160B-0050-SA-S2-AH0-05-N1 Spindle Motor manufactured by Bosch Rexroth Indramat. This motor has a cooling mode with an Axail Fan, Blowing and a Singleturn Absolute, 2048 increments encoder. It also has a mounting style of Flange and a Standard bearing.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MAD160B-0050-SA-S2-AH0-05-N1 Bosch Rexroth asynchronous housing motor can be installed vertically only with the output shaft facing upwards. This motor has an IP 65 protection rating for its power, fan, and encoder connections. The product supports a maximum axial shock load of 10 m/s^2 for 6 ms. This device encounters a temperature change rate of 0.5 degrees C/minute. The unit can be installed at a maximum altitude of 3000 m above sea level. It must be ensured that the application does not exceed the reduced motor data when the ambient operating temperature and installation altitude are exceeded.
This motor is connected to its fan by opening and closing the fan connector. The product is identified by the type designation on its rating plate. This device does not need an additional ground conductor connection. The unit features the power connection on its upper side. Its connection must be established with the manufacturer's cables. This motor must be used in its original state without any structural modification. The product should be operated with a drive controller with variable frequency and output voltage as specified by the manufacturer. This device supports the connection of planetary and control gearboxes under certain conditions. The unit must not be installed or operated in a damaged or defective state. It may be needed to connect additional sensors and actuators to control and monitor the motor.
This motor should be used only with the accessories mentioned in its documentation. The product is capable of performing the application-specific functions only if the drive controller has been programmed before the commissioning process. This device takes up to 140 minutes to cool down. The unit must not be disassembled in the pressurized state. It should be lifted using appropriate equipment and tools in the correct manner. This asynchronous housing motor is not meant to be operated at a speed beyond the specified maximum speed.
