Product Description:

The MAD130B-0150-SA-M0-LK0-05-N1 is a servo motor manufactured by Bosch Rexroth Indramat within the MAD IndraDyn A Motors series. Designed for closed-loop motion axes, this unit converts electrical drive commands into controlled mechanical rotation for industrial equipment. By integrating a permanent-magnet rotor with electronic feedback, the motor supports dynamic acceleration profiles while maintaining position accuracy. Its design follows the servo philosophy of the IndraDyn A family, combining compact dimensions with standardized mounting for machine installation.

Mechanical integration is simplified by its flange mounting interface, and the housing carries a protection rating of IP65, so dust ingress and water jets do not reach the stator windings. During operation, the built-in axial fan forces air along the frame to remove heat generated by the winding, allowing continuous service at the rated speed of 1500 rpm. Command resolution comes from a multiturn absolute encoder that transmits 512 electrical periods per revolution, enabling controllers to recover exact shaft position after power cycles. A standard bearing set supports the rotor, while connections exit on the left side through a connector, reducing wiring complexity. The motor is delivered without a holding brake, so external clamps must secure vertical loads.

The motor is approved for ambient temperatures of 0-40 °C and uses Class F insulation, so the stator can reach elevated internal temperatures without damage to the winding varnish. A frame size of 130 mm with B length gives a moderate torque constant while keeping mass low enough for vibration grade R compliance. Output torque is transferred through a half-key balanced shaft with a seal, which helps limit oil migration into the bearing chamber. Standard bearings, a left-side connector orientation, and the 0150 winding pattern complete the electromechanical configuration.