Product Description

The Bosch Rexroth MAC090C-0-GD-4-C/110-B-0/WI524LV/S014 servomotor has a C length code. This servomotor houses an incremental encoder with standard mounting. This product uses integrated tacho feedback to detect the rotor position and velocity feedback. The device features a laminated core that is embedded with permanent magnets. This unit is not recommended for industrial applications. Its housing is completely closed as per the IP 65 protection category. The motor has a 514 encoder code. This product allows belt pulleys and pinons to be directly mounted on the shaft. This device operates with a mounting flange with throughholes for Design B5 mounting. The unit features minimum installation because of the readymade cables used for this purpose.

This motor absorbs the axial forces through its B side. Its special windings design renders a highly smooth run that makes it ideal for precision lathe operation. The product installation altitude must never exceed 5000m. This device is not prone to damage due to the spraying of water from a nozzle. The unit has continuous torque of 9.6Nm in standstill mode. It has to be ensured that there is no penetration of liquid inside the housing along its output shaft. This MAC090C-0-GD-4-C/110-B-0/WI524LV/S014 servomotor has a year’s backup support from Wake Industrial.

The motor paint can be increased by a thickness of up to 40µm. This product must necessarily undergo a grind in action if it has been stored without use for over two years. The device has its power connector towards the B side. This unit portrays intermittent operating torque with S6 operating mode as per DIN VDE 0530 specifications. It is possible to only solder power cables with inch diameters. The motor has a duty cycle time of maximum of 15 minutes. This product has a continuous current of 24.8A when it is standstill. The device comes with Class F insulation. This servomotor shipment is done to any address irrespective of the country you live in.