IKG0332 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN:
The Bosch Rexroth Indramat IKG0332 is a power cable from the IKG Motor Power Cables series, featuring four 0.75 mm² power conductors and two 0.5 mm² control conductors. It is suitable for drag chains with a bending cycle rating of 5,000,000 and has a PUR jacket in RAL 2003 orange. The nominal outer diameter is 10.0 mm, and the cable supports a maximum conductor temperature of 80°C.
Internal Product Review
The IKG0332 motor power cable from Bosch Rexroth Indramat is designed for high flexibility, featuring 5,000,000 drag chain bending cycles and a PUR jacket for enhanced durability. With 4x0.75 mm² power conductors and 2x0.5 mm² control conductors, it delivers dependable signal and power transmission. This cable stands out for its robust construction and suitability for dynamic industrial environments.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The IKG0332 cable is produced by Bosch Rexroth Indramat for the IKG Motor Power Cables series. It supplies three-phase power and auxiliary control signals between drive controllers and servomotors in industrial automation cells. Designed as a preassembled harness, the cable simplifies cabinet wiring and maintains electromagnetic compatibility by keeping power and feedback conductors separated. Its factory-terminated connectors route energy to moving axes without requiring custom crimping or field soldering. This arrangement also reduces the amount of cable preparation required when the harness is installed in a machine.
Mechanical endurance is supported by a drag-chain rating of 5,000,000 cycles, so the sheath withstands repetitive flexing in dynamic carriers. The outer sheath is made from PUR, a thermoplastic that resists cutting fluids and weld spatter commonly found near machine tools. A nominal diameter of 10.0 mm lets the cable share chain space with sensor leads while remaining compatible with typical clamp sizes. Internally, four 0.75 mm² power cores carry motor phase current, while two shielded 0.5 mm² control cores carry brake or temperature signals. The separation and shielding of these conductors help reduce interference between power transmission and low-level control circuits. The cable can move continuously in a suitable drag chain without developing corkscrew deformation or premature conductor breakage.
Conductor insulation tolerates temperatures up to 80 °C, allowing higher continuous current before derating becomes necessary in warm enclosures. In a permanent installation, the cable permits a minimum bend radius of 5 × D. During dynamic motion, the minimum bend radius increases to 7.5 × D to protect the internal strand geometry from excessive stress. The motor end is fitted with an INS0751 angled connector, while the drive-side plug is coded as INS0757. Both ends are preterminated, eliminating the need to attach contacts after routing the cable. A bright RAL 2003 orange outer jacket improves visibility in cable trays and helps distinguish the cable from nearby signal wiring. Proper bend clearance should be maintained throughout the cable path to prevent localized stress near the connectors and carrier transitions.
