Product Description:

The IKG0210 cable is produced by Bosch Rexroth Indramat within the IKG Motor Power Cables series. Designed for industrial automation, this component carries drive output current to servo motors while maintaining consistent impedance across moving machine axes. By pairing engineered connectors with a mechanically tolerant insulation system, the product allows energy transfer through cable tracks, festoons, or fixed routing without signal degradation.

Electrical performance is supported by a nominal voltage rating of 600/1000 V, indicating the permissible continuous phase-to-ground and phase-to-phase potential. A tough PUR outer jacket protects the core from oils and abrasion during cable-chain cycles, while an overall tinned copper braid shield blocks conducted and radiated interference. Factory-installed terminations use an AEH-to-RKS connector pairing, allowing motors to connect to Rexroth drives without field assembly. During dynamic motion, the conductors may reach +60 °C, while the insulation remains flexible down to -50 °C for use in unheated facilities.

During motion, the cable requires a bending radius of 10 times its outer diameter, while fixed routing permits a radius of six times its outer diameter. For insulation verification, each power core withstands a dielectric test voltage of 4000 V, whereas auxiliary signal pairs are checked at 500 V to verify separation between control and power circuits. The outer sheath is orange (RAL 2003), making energized motor feeds easier to identify inside mixed cable bundles. Continuous static service is permitted at temperatures up to +80 °C, and dynamic travel can begin at -30 °C without cracking the jacket. The IKG design uses conductor geometry and material sequencing intended for motor power applications across Bosch Rexroth drive platforms.