Product Description

The HCS01.1E-W0018-A-03-B-ET-EC-PB-S4-NN-FW is an industrial drive controller from Bosch Rexroth. Controllers from the IndraDrive Cs product line are compatible with a wide range of motors that include the MSM, MSK, and MCL product lines. Features of IndraDrive controllers include compact construction, IP20 protection rating, a control panel with programming module function, scalable signal processing and firmware, multi-encoder interface that works with standard motor encoders, one 14-bit analog input, eight digital inputs, performance-dependent fan control and integrated brake current measurement and monitoring. The basic control section on the HCS01.1E-W0018-A-03-B-ET-EC-PB-S4-NN-FW support encode emulation. The controller works with a standard control panel that does not support hot-plug. Therefore the control panel must be connected to the HCS01.1E-W0018-A-03-B-ET-EC-PB-S4-NN-FW before the latter is switched on. The maximum current output of the HCS01.1E-W0018-A-03-B-ET-EC-PB-S4-NN-FW is 18 Amps.

The controller works with three-phase AC input at 200 to 500 Volts AC. Integrated features available on the HCS01.1E-W0018-A-03-B-ET-EC-PB-S4-NN-FW include a multi-encoder interface and Multi-Ethernet communication. The controller also supports Profibus, which is a standardized and open digital communications system for all areas of application in manufacturing and process automation. In addition, a safety module that support safe motion is also installed on the controller. Bosch has designed the controller for use industrial environments. The unit must only be used as intended. Bosch does not accept any liability for damages resulting from unintended use of its products. All personnel that in any way use Bosch products must read and understand the relevant safety instructions. Bosch does not permit any modification to its product hardware. Bosch also does not permit any modification to product software. Any product, if found damaged or faulty, must not be installed.