Product Description

The Bosch Rexroth HCS01.1E-W0005-A-03-B-ET-EC-NN-NN-NN-AW is an industrial drive controller. It belongs to Bosch’s IndraDrive HCS product line. The controller has a compact construction with IP20 protection rating. As the controller enclosure does not provide protection against dust or moisture ingress, operators must use it indoors. Even if it is used indoors, the controller should be mounted inside a cabinet that provides adequate protection from the elements. Each HCS controller has four main components that include a control section, a power section, a control panel and a controller firmware. The control section on the HCS01.1E-W0005-A-03-B-ET-EC-NN-NN-NN-AW has a basic design. The controller operates over the entire range of AC voltages from 200 to 500 Volts AC. However it is important to note that the controller requires 3-phase input, and does not support 1-phase input.

Maximum output current that the HCS01.1E-W0005-A-03-B-ET-EC-NN-NN-NN-AW controller delivers is 5 Amps. The controller has a modular design that allows operators to install plug in modules of their choice. The pre-installed hardware modules on the HCS01.1E-W0005-A-03-B-ET-EC-NN-NN-NN-AW include a Multi-Ethernet communication module and a multi-encoder interface. Two vacant slots are available on the controller, and operators can install one hardware module and one safety module in these slots. The HCS01.1E-W0005-A-03-B-ET-EC-NN-NN-NN-AW works with an advanced control panel. One of the advantages of an advanced control panel, in comparison to a standard control panel, is that it supports hot plug. This means that operators can connect the advanced control panel to the HCS01.1E-W0005-A-03-B-ET-EC-NN-NN-NN-AW even when it is powered on. The other advantage is that the advanced control panel has significantly more memory than a standard control panel. The HCS01.1E-W0005-A-03-B-ET-EC-NN-NN-NN-AW cools via natural convection and dissipates heat inside the cabinet.