DDC01.2-N200A-R Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat DDC01.2-N200A-R is part of the DDC Digital Intelligent Servo Drives series and has a rated current of 200 Amps with continuous mechanical load capability of 7.5 kW. This servo drive provides resolver feedback for motor control and operates with a power requirement of 22.5 kVA. It features IP65 protection, standard cooling, and weighs 22 kilograms.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The DDC01.2-N200A-R is a servo drive unit built by Bosch Rexroth Indramat for the DDC Digital Intelligent Servo Drives series. It operates as a closed-loop power stage that converts DC bus energy into controlled motor current. Resolver feedback supplies rotor position data so the drive can regulate torque, speed, and position accurately. The unit can control compatible synchronous or induction motors in automated production lines and other machinery that requires coordinated motion.
This drive has a maximum armature output current of 200 A. Its internal bleeder continuously dissipates regenerative power at 0.25 kW and handles short bursts of up to 40 kW. The power input ceiling is 22.5 kVA, which must be considered when sizing upstream fuses and contactors. Gate signals switch at a carrier frequency of 4 kHz, balancing motor noise with semiconductor heat generation. Standard cooling draws ambient air across the heat sink. The drive supplies 45 A of continuous motor current and permits 90 A for short intervals while keeping thermal loading within its operating limits. Noise emission is standard for equipment in the 100 A to 200 A class, allowing the cabinet to use typical shop-floor sound-control measures.
The unit operates at ambient temperatures up to 55 °C, and its enclosure carries an IP65 rating for protection against dust and low-pressure water jets. Operation is permitted at elevations up to 1000 m above sea level before derating is required. The unit has a mass of 22 kg, so suitable lifting equipment should be used during installation. Its regenerated-energy capacity is 20 kW·s, helping protect the DC link during rapid deceleration. Overall power loss is 500 W and must be removed through adequate airflow around the heat sink. The supported motor output is 7.5 kW, making the drive suitable for compatible medium-frame motors. Resolver feedback reports rotor angle to the control system after power is restored. The electronics remain stable at an absolute humidity of 25 g/m³. The product is Series 1 and Version 2.
