Product Description:

The DDC01.2-F100A-DA07-01 is a digital intelligent servo drive produced by Bosch Rexroth Indramat within the DDC Digital Intelligent Servo Drives series. As a closed-loop amplifier, it connects to synchronous motors to regulate torque, speed, and position in automated machinery. The drive serves as the power and control stage between the command source and the motor, allowing automated axes to respond quickly to changing load conditions. It is intended for motion systems that require coordinated rotary control rather than simple open-loop speed regulation.

Electrically, the drive delivers a continuous rated output of 100 A, and its power components are cooled through a liquid cooling circuit that must be maintained by the machine. Motion commands are accepted through an analog interface command module, while rotor position data returns through digital servo feedback to close the loop. The electronics reside in an enclosure complying with IP65, so the unit can be mounted directly on the machine without an additional cabinet. The controller uses function code 07 and version 01, and it is release series 1 with hardware version 2. Noise emission is classified as standard for the 100 A to 200 A rating band, and at least 300 mm of air outlet clearance is required to exhaust residual heat.

Environmental limits permit operation from +5 °C to +45 °C and up to a maximum casing temperature of +55 °C when derating rules are observed. The drive tolerates a peak relative humidity of 95 % as long as condensation is prevented, and the absolute moisture content may not exceed 25 g/m³. Installation altitudes can reach 1000 m above sea level without cooling adjustment, while storage is allowed from −30 °C to +85 °C when the unit is not in operation. These operating and storage limits separate normal service conditions from warehouse exposure. The liquid cooling lines and the required clearance help remove residual heat, and the protection rating helps limit dust entry during humid production shifts.