Product Description:

The DDC01.1-K200A-DL01-01-FW is a digital intelligent servo drive produced by Bosch Rexroth Indramat and placed in the DDC Digital Intelligent Servo Drives series. Within an automation cell, it supplies regulated power to an AC servomotor, processes position feedback, and executes stored motion routines so an axis reaches commanded positions with repeatable accuracy. Its single-unit housing and field wiring terminals allow the drive to be mounted near the machine, which can shorten cable runs between the controller and motor connections. This layout also helps keep installation compact in decentralized motion systems where local drive placement is preferred.

This model is equipped with a command module for single-axis positioning. The control-side supply is 24 V DC, and that same voltage rail is used for typical I/O devices connected to the drive. The interface includes 15 digital inputs for switches and probes, along with 16 digital outputs for status and control signals, so the unit can exchange operating information with surrounding machine devices without additional interface hardware. Motion routines of up to 3000 blocks are stored internally, and the drive delivers a rated motor phase current of 200 A during operation. Diagnostic circuitry adds only a small electrical load and provides an analog signal for external monitoring.

All power electronics are cooled by natural convection, eliminating fans and reducing wear parts in the enclosure. The unit’s maximum logic-side sourcing capability is 100 mA, and closed-loop commutation relies on digital servo feedback from the attached motor to maintain accurate rotor information during operation. A rugged die-cast enclosure with an IP65 protection category supports use in areas exposed to dust or low-pressure water jets. The product is series 1 and version 1, and its published noise data places it in the standard 100 A to 200 A range.