Product Description:

The DDC01.1-K150A-DL01-01-FW is a digital intelligent servo drive manufactured by Bosch Rexroth Indramat within the DDC Digital Intelligent Servo Drives series. Classified as a single-axis controller, it converts incoming power into regulated output for coordinated motion in automated production cells. Embedded positioning logic and digital motor feedback allow the unit to govern speed and position directly, so it can serve as both a power amplifier and an axis processor for conveyor segments, pick-and-place heads, or machine-tool slides. This layout supports local motion control on the axis instead of relying entirely on external control hardware for every movement sequence.

The drive delivers a continuous output of 150 A, and its main terminals accept three-phase AC power at 50 to 60 Hz. Operation takes place inside an IP65 housing, which helps protect the electronics from dust and washdown spray in enclosed machine areas. The single-axis positioning command module stores 3,000 motion program blocks, allowing repetitive sequences to remain in the drive and reducing dependence on a higher-level controller for short routines. Overvoltage protection trips at 475 V, and three selectable fault reactions can be assigned to match the required machine response. Communication and I/O are routed through the X31 9-pin and X30 34-pin DLC connectors, giving the unit dedicated paths for external control and interface signals.

After mains power is removed, the DC bus discharges within 5 min. Cooling is provided by natural convection, so the enclosure needs unobstructed airflow but no fans. The onboard DLC port supports RS232/RS485 for setup or host supervision, giving the unit a direct serial link for local access and supervisory communication. A commanded stop releases torque after 500 ms, and the noise emission falls within the 100 A to 200 A band during operation. Motors that remain below the holding-brake speed limit can stay stationary without mechanical locking.