Product Description:

The DDC01.1-K100A-DS50-00-FW is a servo drive produced by Bosch Rexroth Indramat for the DDC Digital Intelligent Servo Drives series. It converts set-point data from a motion controller into regulated motor current, allowing precise positioning and velocity control on automated machinery such as gantries, packaging stations, and handling robots. The unit supplies power to the motor, performs real-time monitoring, and communicates diagnostic status to the supervisory PLC so the axis can be integrated into coordinated multi-drive systems. This arrangement helps the drive support repeatable motion during changing load conditions and frequent start-stop cycles.

The drive delivers a continuous phase current of 100 A, providing headroom for motors that require high torque during acceleration. It is designed for a three-phase supply of 3 × 230 V AC, so it can connect directly to common factory mains. An enclosure rating of IP65 allows installation outside a sealed cabinet because the housing blocks dust ingress and low-pressure water jets. The housing has a frontal width of 500 mm and a depth of 298 mm, so machine layouts can reserve enough space for mounting and cable bends. Motor leads can be routed up to 75 m without exceeding the stated voltage drop or EMC limits, which supports flexible placement on large production cells.

The command module uses the SERCOS interface, enabling deterministic fiber-optic communication for synchronized multi-axis motion. Heat is removed by natural convection air cooling, so no additional fans are required. Position data is returned through digital servo feedback, allowing the control loop to correct errors at each communication cycle. This combination supports stable axis response during coordinated acceleration, deceleration, and hold positioning. It also helps keep motion performance consistent when several axes share the same control network.