Product Description:

The DDC01.1-K100A-DL01-00 is a digital intelligent servo drive produced by Bosch Rexroth Indramat within the DDC Digital Intelligent Servo Drives series. Designed as a self-contained controller for one electromechanical axis, the unit converts fixed-frequency mains power into regulated three-phase output for synchronous or induction servomotors. Integrated motion logic and closed-loop current regulation let the drive handle velocity and position tasks directly, so it fits packaging machines, material handlers, and general automation where distributed axis control and limited cabinet space are common.

Its power section accepts a line supply of 3 × 230 V AC, and the inverter can continuously source up to 100 A of motor current. The input stage tolerates fluctuations within +10% / -15%, allowing stable operation on utility grids that deviate from nominal values. Heat is removed by natural convection, so no additional fans are required as long as unobstructed airflow surrounds the heat sink. The internal NC processor stores application logic in a memory space of 3000 blocks, allowing point-to-point sequences, dwell times, and velocity changes without an external PLC. Function code 01, version 1, and series 1 indicate the assigned product generation for compatible Indramat tools.

A pre-installed command module provides single-axis positioning capabilities, so the drive can calculate trajectories and monitor completion feedback on its own. Position and speed signals return through digital servo feedback, enabling fine resolution and automatic parameter adaptation for each connected motor. The housing is sealed to IP65, which blocks dust ingress and water jets and permits direct mounting on machine frames outside of a control cabinet. During nominal operation, the unit follows the manufacturer’s standard noise level (100 A–200 A) classification, keeping airborne sound within typical factory expectations while the current loop runs at full load.