DDC01.1-F100A-RS45-00-FW Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
The Bosch Rexroth Indramat DDC01.1-F100A-RS45-00-FW is part of the DDC Digital Intelligent Servo Drives series. This digital intelligent servo drive has a rated current of 100 Amps and supports a SERCOS interface with optical fiber cables. It uses liquid cooling, operates at 3 x 230 V AC input, and offers resolver feedback for motor control along with IP65 protection.
Internal Product Review
The DDC01.1-F100A-RS45-00-FW is a digital intelligent servo drive featuring a SERCOS interface and liquid cooling. The 100 A rated current and IP65 protection make the drive well suited for demanding servo installations. Resolver feedback adds dependable motor response, making the unit an excellent choice for precise motion control.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
Bosch Rexroth Indramat’s DDC01.1-F100A-RS45-00-FW belongs to the DDC Digital Intelligent Servo Drives series and is used as a closed-loop actuator supply in industrial automation. The unit converts three-phase mains power into controlled output that drives synchronous or induction motors while monitoring current, voltage, and thermal limits. By integrating power electronics, resolver feedback, and a SERCOS communication module in one housing, it simplifies axis control on packaging lines, material-handling gantries, and similar equipment.
The drive delivers a continuous output of 100 A; this current sets the thermal load that its bus bars, IGBTs, and liquid heat sink must withstand during steady operation. Supply power is accepted from 3 × 230 V AC, so the unit can connect directly to compatible plant distribution without a step-up transformer. A liquid cooling circuit removes switching losses, allowing dense mounting where airflow is restricted. Transient protection is handled by an overvoltage cutoff at 475 V, and an overcurrent trip engages when line amperage reaches 1.5 × the rated current; both thresholds disconnect the inverter before semiconductor damage occurs. If DC-bus energy rises quickly during deceleration, the bleeder issues a warning at 75 percent of its continuous power, allowing the controller to adjust braking profiles. The control electronics require a 100 ms power-on pulse to start, and undervoltage logic halts pulses below 200 V to prevent erratic gating.
An enclosure rating of IP65 seals the chassis against dust ingress and water jets, so the unit can be mounted on the machine frame without a separate cabinet. Command data travel through the SERCOS interface over optical fiber cables, providing deterministic timing and electrical isolation from noisy motor leads. Resolver feedback can be routed up to 75 m, which suits large cells where drives are located far from moving axes. Operating conditions allow up to 95 percent relative humidity and an installation altitude of 1,000 m. The standard noise emission band for drives rated from 100 A to 200 A indicates typical sound levels for industrial operation.
