ZS2001-0004 Beckhoff
Wake Industrial LLC is not an authorized distributor of this product.
The Beckhoff ZS2001-0004 is part of the ZS Motion Accessories series and features a 30-pin female contact type made of CuZn and PBT materials. This accessory supports a rated current of 2 Amps at 20°C, a rated voltage of 50 Volts, and utilizes clamping yoke connection for wire termination. The item has a gray body color, weighs 0.023 kg, and provides an IP20 protection rating.
Internal Product Review
The ZS2001-0004 is a Beckhoff female connector for motion accessory interfaces, built with 30 pins. Clamping yoke termination and CuZn contacts give the connector a precise, technician-friendly connection point during assembly. IP20 protection and 1 GΩ insulation resistance make the unit a dependable choice for enclosed industrial installations.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The ZS2001-0004 connector belongs to the ZS Motion Accessories series from Beckhoff, a manufacturer of modular motion hardware used in automated machinery. This accessory is a 30-position female contact carrier that brings signal and low-voltage power lines together in one compact element for axis assemblies and control panels. Its molded gray body and clamping-yoke wire termination shorten installation time and maintain consistent conductor strain relief, giving machine builders a repeatable interface between moving components and stationary control hardware.
The carrier has a 30-pin layout, arranged to keep logic and supply circuits separate while still fitting into tight cabinet layouts. Each path can carry up to 2 A at 20 °C, so modest sensor loads or brake coils can share the same plug without exceeding thermal limits. System voltage on any pole must remain below 50 V, aligning the accessory with extra-low-voltage control zones for operator safety. Environmental sealing is limited to IP20, so the part is intended for protected enclosures rather than washdown areas. The average mating effort is 8 N/pole, which provides firm retention while still allowing the connector to be disconnected during routine service without specialized tools.
Dielectric reliability is supported by an insulation resistance of 1 GΩ, minimizing leakage when adjacent circuits differ in potential. Mechanical endurance is rated for 25 complete insertion cycles, so the connector is intended for occasional mating and unmating rather than frequent changeovers. An integrated diagnostic LED draws only 0.8 mA at 24 V, allowing continuous status indication without noticeable load on the controller’s auxiliary supply. Each piece adds just 0.023 kg to the harness, helping keep dynamic cable chains light and responsive.
