ZS2000-2210 Beckhoff
Wake Industrial LLC is not an authorized distributor of this product.
The Beckhoff ZS2000-2210 is a male plug connector from the ZS Motion Accessories series with a 3-pin, A-coded design and an M8 installation size. It features screw locking, supports rated currents of 4 Amps at 40°C, and operates at up to 60 Volts. The connector has a protection rating of IP65/67 when screwed and weighs 0.028 kilograms.
Internal Product Review
The ZS2000-2210 is a Beckhoff M8 plug connector with a 3-pin layout suited to compact motion accessory interfaces. Screw connection termination supports clean, secure assembly, while IP65/67 protection when screwed stands out for dependable industrial service.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The ZS2000-2210 is a compact industrial connector produced by Beckhoff for the ZS Motion Accessories series. It is supplied as a male plug intended for sensor, actuator, or auxiliary power links on motion platforms and I/O modules. By providing a standardized interface between field devices and the drive cabinet, the component simplifies cable harnessing and maintains consistent signal quality across distributed automation cells. Its compact form also helps it fit into tight mounting areas where larger circular connectors would take up more clearance around sensors, small actuators, and nearby cable runs.
The connector follows the M8 installation format and uses an A-coded key so it can be aligned quickly with matching sockets and helps prevent cross-wiring between power and signal circuits. A three-pin contact layout supports discrete signals or low-power supply lines up to 4 A at 40 °C, while a nominal line potential of 60 V covers most 24 V and 48 V control loops with margin for transient peaks. Once the plug is inserted, a knurled metal nut engages a screw locking system that maintains the rated seal of IP65/67 against dust and water jets when fully tightened. The unit is delivered without shielding, so cable designers can reserve the braided layer for noise-sensitive channels instead. Both the conductor cores and the protective earth lead terminate on internal clamp blocks that accept screw connections, enabling tool-based rework instead of soldering during installation.
An insulation resistance of 100 MΩ protects adjacent circuits from leakage when the plant runs humid or oil-laden processes. Mechanical endurance is documented for at least 100 mating cycles, and the stainless thread tolerates assembly forces up to 0.4 Nm without galling, which helps protect the sealing ring across repeated service work. At only 0.028 kg, the connector adds minimal mass to moving cable chains and reduces pull on small photoelectric sensors or valve islands mounted on fast linear axes. The low mass also helps limit added strain at cable entry points when the connected device moves through short, repeated travel cycles.
