ZK4510-0000-0250 Beckhoff
Wake Industrial LLC is not an authorized distributor of this product.
The Beckhoff ZK4510-0000-0250 is part of the ZK Motor Cables series and features a 25 meter cable length with a 17-pin M23 female plug and 15-pin D-sub male socket. This cable has a maximum rated current of 7 Amps, an impulse voltage of 2.0 kV, and shield coverage of at least 85 percent. Its protection ratings are IP66/67 on connector A and IP20 on connector B, while the operating temperature range for fixed installation is -40 to 80 degrees Celsius.
Internal Product Review
The ZK4510-0000-0250 is a Beckhoff motor cable with an M23 female 17-pin plug and a 15-pin D-sub male socket. Shield coverage of at least 85% and contact resistance below 5 mΩ support clean, stable transmission in servo applications. IP66/67 protection at connector A makes this cable a strong choice for dependable industrial connectivity.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The ZK4510-0000-0250 is a pre-assembled motor cable produced by Beckhoff within the ZK Motor Cables series. It links servo amplifiers and rotary motors while carrying power, brake, and encoder lines in one jacket, which reduces separate cable runs in automated machinery. The cable is intended for distributed drive layouts where factory-installed connectors simplify installation and help preserve stable signal transmission. This layout reduces clutter where motors, brakes, and feedback devices share the same route.
A length of 25.0 m allows the cabinet to be placed farther from the axis without requiring splices. The motor side uses a 17-pin female M23 plug, and the drive side terminates in a 15-pin male D-sub socket, so power conductors and feedback contacts connect through standard interfaces. The conductor bundle uses a 7×2×0.14 mm² plus 2×0.5 mm² cross-section, and contact resistance stays below 5 mΩ to keep losses low over the full run. Rated insulation withstands impulse voltages up to 2.0 kV, and the signal cores operate at 30 V while the jacket is approved for 125 V AC/DC service at currents up to 7 A maximum. A braided shield covers ≥ 85% of the circumference, which helps limit electromagnetic interference in nearby control wiring.
The thermoplastic outer jacket has a diameter of 7.6 mm ± 0.3 mm, accepts static tensile stresses of 50 N/mm², and tolerates torsion of ±30 °/m for use in drag chains and rotary tables. Insulation resistance remains at least 20 MΩ·km, which helps preserve feedback quality in humid areas. Continuous operation is permitted from -40 to +80 °C, and when the screw coupling on side A is engaged, the assembly reaches IP66/67 protection, while the controller interface remains IP20. The protected motor-side connection helps the cable withstand dust and water exposure on the machine.
