ZK4500-0004-0200 Beckhoff
Wake Industrial LLC is not an authorized distributor of this product.
The Beckhoff ZK4500-0004-0200 is a motor cable in the ZK Motor Cables series designed for fixed installation with a cable length of 20 meters and made from bare copper conductors. It has an orange PVC jacket, a power connector with 8 positions in M23 size, and supports a maximum operating voltage of 1000 V AC. The cable features insulation made of PP material and a minimum bending radius of 238 mm.
Internal Product Review
The Beckhoff ZK4500-0004-0200 is a motor cable built for fixed installation. An M23 power connector with Speedtec® locking supports fast, secure connection in servo and drive assemblies. Bare copper conductors and a 1000 V AC rating make this cable a strong choice for dependable power transmission.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The ZK4500-0004-0200 motor supply cable is produced by Beckhoff within the ZK Motor Cables series. It is an 8-conductor power and feedback line intended for fixed installation between AX series drives and synchronous servomotors in automated machinery. By combining preassembled connectors with industrial-grade insulation and jacketing, the cable carries motor current, signal reference, and protective earth while simplifying field wiring on assembly lines and material-handling equipment.
At a length of 20 m, the assembly arrives ready-to-run, eliminating on-site cutting or terminations. Its conductors are bare copper with a cross-section of 2.50 mm², providing the ampacity required for servo phases while keeping loop resistance low. The maximum line-to-ground potential is 1000 V AC, so the cable can be routed alongside standard machine power circuits without derating. Mechanical flex points are protected by a minimum permissible bend of 238 mm, a value that must be respected during routing through cable trays and machine frames. An integrated M23 plug contains 8-pin contacts that separate phase, neutral, and feedback leads to maintain signal integrity under dynamic loads.
The structure contributes to a mass of 288 kg/km, a parameter used when calculating drag-chain forces or support tray loading for long horizontal runs. Longitudinal stresses up to 50 N/mm² can be tolerated in fixed routing, so cable grips and strain-relief hardware must be selected accordingly. Electrical leakage is minimized by an insulation resistance of 10 MΩ·km between cores, with polypropylene primary insulation and a polyvinyl chloride jacket that is colored orange for fast visual identification. Connection repeatability is aided by the Speedtec® bayonet lock, and the connector contacts are rated for 500 complete mating cycles, supporting periodic service without re-termination.
