ZK1090-9191-0002 Beckhoff
Wake Industrial LLC is not an authorized distributor of this product.
The Beckhoff ZK1090-9191-0002 is a motor cable from the ZK Motor Cables series with a length of 0.26 meters and a structure of 4 x 2 x AWG26. The cable features a PUR jacket, polyethylene insulation, and a shield coverage of 90 percent. It is rated for a current of 1 amp at 50 degrees Celsius and 160 volts, with a test voltage of 1000 V at 50 Hz for 1 minute.
Internal Product Review
The ZK1090-9191-0002 is a Beckhoff motor cable with a PUR jacket and PE insulation, giving the assembly a durable and clean industrial build. Signal performance looks strong thanks to 90% shield coverage and 32.3 dB/100 m near-end crosstalk at 100 MHz. A mating life of at least 750 cycles and a 1000 V test rating make the cable a very solid choice for reliable machine connections.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The ZK1090-9191-0002 motor cable is produced by Beckhoff as part of the ZK Motor Cables series. This pre-assembled lead is intended for short interconnections between servo drives and motors in control cabinets, providing both power conductors and twisted signal pairs required for deterministic motion control. Its compact design minimizes excess slack in dense enclosures, and the molded connectors permit quick replacement without field crimping or soldering.
At only 0.26 m in length, the cable fits tight panel layouts while keeping transmission paths short. Internally it follows a 4 x 2 x AWG26 structure; eight conductors are arranged as four balanced pairs so differential feedback channels remain resistant to external noise. Each conductor has a cross-section of 0.14 mm², providing adequate current capacity for encoder supply lines. High-frequency attenuation is measured at 22.4 dB/100 m at 100 MHz, a figure that predicts negligible signal loss over this short run. A tinned copper braid with 90% optical coverage surrounds the core, diverting radiated emissions and protecting neighboring devices from conducted disturbances. The PUR outer jacket resists oils and mechanical abrasion, while the PE insulation inside maintains pair geometry under bending. Additional parameters include a loop resistance of 280 Ω/km, near-end crosstalk of 32.3 dB/100 m at 100 MHz, and a minimum of 750 mating cycles for the plug set.
A signal propagation delay of 5.08 ns/m supports synchronous sampling when several axes share a common clock domain. Dielectric strength is verified by a test voltage of 1000 V for one minute at 50 Hz, confirming insulation integrity. Volume resistivity is ≥10 GΩ, limiting leakage currents that could skew analog transducer readings. The mutual capacitance between paired conductors is only 51 pF/m at 1 kHz, allowing precise edge detection by the drive's receiver circuits even at low amplitudes. The cable is intended for short cabinet-level runs where low delay, controlled capacitance, and shielding help preserve signal quality between the drive and motor in compact panels.
